ジョージの技術備忘録

参考したサイトを忘れないための備忘録

Lチカ

Arduinoのサンプルコードに少し手を加えました。

/* Blink without Delay
 
 Turns on and off a light emitting diode(LED) connected to a digital  
 pin, without using the delay() function.  This means that other code
 can run at the same time without being interrupted by the LED code.
 
 The circuit:
 * LED attached from pin 13 to ground.
 * Note: on most Arduinos, there is already an LED on the board
 that's attached to pin 13, so no hardware is needed for this example.
 
 created 2005
 by David A. Mellis
 modified 8 Feb 2010
 by Paul Stoffregen
 modified 11 Nov 2013
 by Scott Fitzgerald
 
 
 This example code is in the public domain.
 
 http://www.arduino.cc/en/Tutorial/BlinkWithoutDelay
 */

// constants won't change. Used here to set a pin number :
const int ledPin =  13;      // the number of the LED pin

// Variables will change :
int ledState = LOW;             // ledState used to set the LED

// Generally, you shuould use "unsigned long" for variables that hold time
// The value will quickly become too large for an int to store
unsigned long previousMillis = 0;        // will store last time LED was updated

// constants won't change :
const long interval = 1000;           // interval at which to blink (milliseconds)

void setup() {
  // set the digital pin as output:
  pinMode(ledPin, OUTPUT);      
  Serial.begin(115200);//シリアルモニタの宣言 通信速度11520 [bit/s]
}

void loop()
{
  // here is where you'd put code that needs to be running all the time.

  // check to see if it's time to blink the LED; that is, if the 
  // difference between the current time and last time you blinked 
  // the LED is bigger than the interval at which you want to 
  // blink the LED.
  
  unsigned long currentMillis = millis();
 
  if(currentMillis - previousMillis >= interval) {
    // save the last time you blinked the LED 
    previousMillis = currentMillis;   
    Serial.print(currentMillis/1000);//情報出力\n
    // if the LED is off turn it on and vice-versa:
    if (ledState == LOW){
      ledState = HIGH;
      Serial.println(",Light On");//情報出力
    }
    else{
      ledState = LOW;
      Serial.println(",Light Off");//情報出力
    }
    // set the LED with the ledState of the variable:
    digitalWrite(ledPin, ledState);
  }
}

f:id:yoshida-hideki94:20160521204903p:plain:w200:h200